TELEDYNE OLDHAM SIMTRONICS Everywhereyoulook MultiFlame DF-TV7, Operating Manual

Page: 50 / 64

MULTIFLAME DF-TV7
OPTICAL FLAME DETECTOR
OPERATING MANUAL
44 NOSP17662
Revision 03
Acknowledge (Alarm, CEDPC LED) :

Apply the magnetic wand on PG1 or PG2 for 3 seconds.
The green LED blinks quickly for 3 seconds to indicate that the operation is fully complete.
LT15 test:
 Apply the magnetic wand on PG1 for 10 seconds.
The green LED blinks at 2Hz to indicate that the detector is LT15 mode. This mode is active for 10
minutes. If the user wants to exit to this mode without waiting 10 minutes, he must hold the wand
on PG1 or PG2 for time > 10 seconds.
In the two cases, the green LED blinks at 5 Hz during 10s to indicate that the detector is going to
exit this mode.
Flame simulation :

Apply the magnetic wand on PG2 for 10 seconds.
Perform the same operation as LT15 mode.
The table below gives you the different LED status along with the indication:
LED Status Green LED Red LED
Steady
•
magnet detected
Blinking
0.5 Hz
•
normal mode
•
magnet not detected
•
no fault
•
no communication with the TLU
Blinking
1 Hz
•
detector is communicating with the TLU
Blinking
2 Hz
•
in LT15 or flame simulation mode
•
request for sensor identification by
HART
Blinking
5 Hz
•
during 3s : Reset Acknowledgement
•
during 10s : Detector is exiting the LT15
or flame mode
•
Alarm
•
CEDPC Alarm is latched
Blinking
(100ms every 3
seconds)
•
Detector Fault