Operator’s Manual Simple TrueArb
Application
45
Waveform Editor
–
Use this button to open
the
Waveform Editor software. (For more
information please refer to the Waveform
Editor User Manual).
License button
–
Use this button to enter the
License setup page. (For more information,
please refer to the relative section).
Settings
Touch the “Settings”
button to open the page relative to the Device Settings, Channel Settings,
Marker Setting and Sequencer Setting.
Device Settings
The device settings are common for all the instrument and they are grouped in General settings, Timing
settings and Trigger settings.
General
Run Mode
The Run Mode defines the sequencer execution flow:
•
Continuous
: when the RUN/STOP button is pressed each waveform will loop as written in the
entry repetition parameter and the entire sequence is repeated circularly until the user presses
the RUN/STOP button as shown in the picture below
