© Telect, Inc., All Rights Reserved, 12.7.16 v.4
1.509.926.6000 :: telect.com
41
User Manual
Advanced Distribution Frame (ADF) Systems
c. Fasten with M6 screws near the front. Torque the M6 screws to approximately 5 N•m.
Telect, Inc. • USA +1.509.926.6000 • 52.33.3836.37.52
www.telect.com • © 2010 Telect, Inc., All Rights Reserved, 119736-4
Page 4-41
c. Fasten with M6 screws near the front. Torque the M6 screws to approximately 5 N•m
Guide Pins on Tray Modules Slip
Keyways
into Keyways on ADF
M6 Panhead Screws
Secure Module
Pivot Trays Inward About 15°
Close and latch
trays on latch bar
to Make Installation Easier
to ADF
2b
2a
2b
2c
Figure 36 - Installing a Module on a Main ADF
.
3. The trays should latch easily. If the trays are not properly aligned, adjust the latch bar as fol-
lows:
NOTE:
Latch bar adjustment may be necessary only during installation of the first module
(with trays) in a quadrant. After the first module with trays is in place, all subsequent modules
installed in that quadrant will align automatically.
a. Make sure all trays are rotated out, away from the latch bar.
b. Loosen the six adjustment screws that hold that latch bar — there are four latch bars, one
per quadrant per Main ADF — to the frame extender. See Figure 37, following.
Figure 36 - Installing a Module on a Main ADF
3. The trays should latch easily. If the trays are not properly aligned, adjust the latch bar as follows:
NOTE:
Latch bar adjustment may be necessary only during installation of the first module (with trays) in a
quadrant. After the first module with trays is in place, all subsequent modules installed in that quadrant will
align automatically.
a. Make sure all trays are rotated out, away from the latch bar.
b. Loosen the six adjustment screws that hold that latch bar — there are four latch bars, one per quadrant
per Main ADF — to the frame extender. See Figure 37, following:
