A C C E S S 2 4 1 - F X O / 2 4 1 / 2 1 1 / 2 1 1 N V O I P G A T E W A Y U S E R G U I D E
MN100129 Rev E
23
Installing Your Access 211/Access 211N VoIP Gateway with a Home
Network
Figure 4: Access 211/ Access 211N Home Network Installation
1.
Unpack the Gateway.
2.
Verify you have the components listed in the
list above.
3.
Place the Gateway on a desktop or other level surface, or mount it on a wall. Choose a
location that is near the devices to be connected and close to a wall socket.
4.
Connect the WAN port on the Gateway’s rear panel to the Ethernet socket on your
broadband modem with an Ethernet 10/100BaseTX (RJ-45) cable.
5.
Connect the LAN port on the Gateway’s rear panel to an open Ethernet LAN port on your
router or switch using the supplied Ethernet 10/100BaseTX (RJ-45) cable, in accordance
with the instructions provided with your router or switch.
6.
Connect the phones to the Phone1 and Phone2 sockets on the Gateway rear panel with RJ-11
Phone cables. Up to five phones in parallel may be connected to each port. (If your provider
enables only one phone line, use the Phone1 port).
7.
Verify that all system components are properly installed. Secure all cable connectors in the
appropriate ports.
8.
Connect the power adapter to the power connector of the Gateway and to a wall socket.
9.
Check that the Power LED on the Gateway front panel glows steadily.
