A C C E S S 2 4 1 - F X O / 2 4 1 / 2 1 1 / 2 1 1 N V O I P G A T E W A Y U S E R G U I D E
MN100129 Rev E
22
10.
T urn on the PC and perform the following:
10a. If you are using a DSL modem, you will need to enable PPPoE on the Gateway and disable
PPPoE on the PC. To enable PPPoE on the Gateway:
1)
Open the web browser and put the IP of the Gateway in the address field (the factory
default IP address of the LAN interface is 192.168.100.1).
2)
In the vertical menu bar on the left of the Gateway Web page, select WAN.
The WAN Status page appears.
3)
In the horizontal menu bar of the WAN page, select PPPoE. The WAN PPPoE
Configuration page appears.
4)
Select Yes in the Enable PPPoE drop-down list box.
5)
Fill in the username and password in the Authentication fields as supplied by your DSL
provider. Optionally you can enter the service name for the requested service. To select a
specific provider, enter his access name in the AC name field.
6)
Click Save PPPoE Settings.
7)
After entering and saving all configurations, you must reset the Gateway. In the vertical
menu bar of the current page, select Reset. The Reset page appears.
8)
Select Power on reset and click the Reset button. The Gateway power cycles and the
application’s home page opens with the new configuration settings.
For more information, see section “
Enabling Point-to-Point Protocol over Ethernet
)”.
10b. If you are using a cable modem, note that some cable modems need to be powered off and
then on after being connected to the Gateway. For such modems you can also power off the
Gateway and then power on for faster connection.
11. For
Access 211
- Wait for the Voice LED to glow, indicating that you are connected to your
VoIP service providers. It may take a minute or two for these connections to be established.
For
Access 211N
- Wait for the respective Phone (Voice) LED (Phone1 for PH1
port/Phone2 for PH2 port) to glow, indicating you are connected to your VoIP service
providers. It may take a minute or two for these connections to be established.
12.
Verify that your broadband Internet service functions properly.
13.
Pick up the phone on each line to verify that you can hear the dial tone.
