TIG 3000 D
Vers. 002
10
GB
4.2.2 Hanging installation
The generator is provided with supporting brack-
ets designed for fixing in a hanging configuration.
Figure 6 shows the arrangement of the fixing
brackets and vibration damping cylinders.
Figure 7 shows the generator with the mounting
brackets and damping mounts correctly installed
on the generator.
The vibration damping cylinders are
designed to work in compression and must
be assembled as shown in figures 6 and 7.
Installation in a pulling configuration as
shown in fig. 8 is strictly not permitted!
Ensure that the ride height of the gen-
erator is not such as to risk contact with the
ground during travel. A good rule is to ensure
that the ride height of the lowest point of the
generator is not less than that of the other
components of the vehicle on which it is in-
stalled.
4.2.3 Floor mounting
Is it possible to install
TIG3000D
on a flat sur-
face. To do this, remove the screws (fig. 9 ref. 2)
that secure the four supporting brackets (fig. 9
ref. 1), turn them by 180 degrees and fix them as
shown in fig. 9. After operation completion make
sure that all the screws that lock the four brack-
ets are securely tightened.
Summary of Contents for TIG 3000D
