Vers. 002
Energy 4010 D
GB
13
5.4 Battery Connection
To start up the generating set, you must connect
to the vehicle battery using a sheathed cable (to
determine its cross-section, see Table 1) in
compliance with the regulations in force.
For this purpose, the generating set is provided
with two terminals (fig. 18) used to connect the
positive and the negative poles of the battery.
Connect the positive pole cable (red cable) to the
terminal which is already provided with a red
cable (fig. 18 ref. 3) and the cable of the negative
pole (black cable) to the
terminal already
provided with a black cable (fig. 18 ref. 4). The
cable of the negative pole must be of the same
cross-section as the positive cable and must be
connected to both the negative pole of the
battery and the chassis of the vehicle.
The contact must be good. If necessary, remove
any paint or rust from the contact surface, and
protect the connection with grease.
The start-up battery must have a capacity of at
least
80 A/h.
The battery connected is recharged by the
generator with a max current of 5 A.
Always fit a 100 A fuse
onto the cable connecting the generating set
to the positive pole of the battery.
5.5 Electronic Control Panel Connection
Choose the position you want inside the vehicle
and make a rectangular hole sized 30 x 32 mm.
Identify the path for laying the connection cable
(fig. 22) from the control panel to the generating
set.
We remind you that a 5 m long cable is delivered
standard. Optional cables in longer sizes are also
available
:
7 m (code 03797), 10 m (code 03798),
15 m (code 03799).
Arrange the connection cable (fig. 22) so as to
connect the black connector side (fig. 22 ref. 1) to
the control panel, and the white connector side
(fig. 22 ref. 2) to the generating set.
Let the connection cable coming from the
generating set out of the hole and connect the
black connector of the cable (fig. 22 ref. 1) on the
back of the electronic control panel. Fasten the
electronic control panel (Fig. 21) using self-
tapping screws sized 3 x 20 mm, and make sure
that the rear part does not touch other surfaces;
use slight pressure to fasten the plastic frame
until you hear the click of the fastening tabs.
Connect the other end of the connection cable
(fig. 22 ref. 2) to the proper white connector (fig.
23 ref. 1) which is located on the side of the
generator control box; observe proper connection
side.
Summary of Contents for Energy 4010D
