Telair Energy 4010D, Use And Maintenance Manual

Page: 19 / 44

Vers. 002
Energy 4010 D
GB
19
A clogged air filter will
reduce air flow to engine. To prevent engine
malfunction, check the air filter regularly. If
the engine is used in a heavily dusty
environment, we suggest checking the air
filter every time before starting up the engine.
Never use Diesel oil or
solvents with a low evaporation point for
cleaning the air filter cartridge, as this could
cause fires or explosions.
Never operate the engine without an air filter; the
engine would wear down quickly.
The filter element is located in a plastic box (fig.
29 ref. 1) To remove the filter element, open the
lid of the box by screwing out the suitable knob
(fig. 29 ref. 2).
After removing the lid, screw out the filter knob
(fig. 30 ref. 2) and take out the air filter (fig. 30
ref. 1).
Slightly beat the element on a hard surface to
remove the excess dust or blow compressed air
inside out (fig. 31 ref. 1). Never brush the filter
element, as this would push dust in between the
fibres. Replace the filter element if excessively
dirty.
8.3.3 Oil filter maintenance
Scalding hazard due to
boiling oil. Spent oil should be collected and
disposed
of without polluting the
environment in compliance with the
applicable law provisions in force.
Perform oil filter
maintenance every 500 running hours
To clean the engine oil filter cartridge, this must
be removed from its seat.
Screw out the closing plug (fig. 32 ref. 1).
Take the filter out of its seat (fig. 33 ref. 1).