Advanced Features and Troubleshooting Manual
169
Material Safety Data Sheets for Phaser 750 Printers
MSDS for Toner
SECTION 1- PRODUCT IDENTIFICATION
Trade Names Tektronix Part Number
Black Toner Cartridge 016-1803-00, 016-1807-00
Cyan Toner Cartridge 016-1800-00, 016-1804-00
Magenta Toner Cartridge 016-1801-00, 016-1805-00
Yellow Toner Cartridge 016-1802-00, 016-1806-00
Product Use:
Tektronix Phaser 750 printer.
SECTION 2 - INFORMATION ON INGREDIENTS
Ingredients
: Toners are a proprietary blend of resins and pigments, encased in a cartridge.
SECTION 3 - HAZARDS IDENTIFICATION
ROUTES OF EXPOSURE:
Toner powders are encased in a cartridge. Minimal exposure through
inhalation or skin contact is expected when used as intended.
POTENTIAL HEALTH EFFECTS:
Health effects from this product are expected to be negligible,
when product is used as intended.
Immediate Effects:
Inhalation:
Minimum irritation to respiratory tract, as for any non-toxic dust.
Skin:
Expected to be low hazard to skin, when used as intended.
Eye:
May cause mild irritation.
Ingestion:
Not an expected route of exposure.
Chronic Effects:
None known or expected.
SIGNS AND SYMPTOMS OF EXPOSURE:
Minor irritation to respiratory tract, skin, and eyes.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE:
None known.
SECTION 4 - FIRST AID MEASURES
INHALATION:
Unlikely route of exposure. In the event of exposure, remove person to fresh air.
Seek medical attention if symptoms occur.
EYES:
If particles get into eye, flush thoroughly with water. Seek medical attention if symptoms
occur.
SKIN:
Wash thoroughly with water. Seek medical attention if symptoms of irritation occur.
INGESTION:
Seek medical attention immediately.
SECTION 5 - FIRE FIGHTING MEASURES
FLASH POINT
: Not applicable.
FIRE & EXPLOSION HAZARDS:
These toners will burn. Like most organic powders, explosive
mixtures can form when powder is dispersed in air.
EXTINGUISHING MEDIA:
Use CO2, dry chemical, foam, or water.
FIRE FIGHTING INSTRUCTIONS:
Avoid inhalation of smoke. As for any fire, wear protective
clothing and self-contained breathing apparatus.
SECTION 6 - ACCIDENTAL RELEASE MEASURES
SPILL OR LEAK:
Toners are encased in a cartridge. However, in case of breakage, toner powders
may be cleaned up with a broom or vacuum. Sweep slowly to minimize dust generation. If a vacuum
is used, the motor must be dust tight. Clean up residue if necessary with soap and water. Wash or
dry clean garments after removing loose toner.
SECTION 7 - HANDLING AND STORAGE
HANDLING:
No special precautions
STORAGE:
Avoid high temperatures.
