Tektronix H600 RFHawk, Service Manual

Page: 61 / 109

Removal and Replacement Procedures
Table 4-1: Tools required (cont.)
Item
no.
Name Description General Tool number
6.
1/4 inch nut driver
Used to remove
standoffs
Standard tool
7. Torque driver Accepts Torx tips, Pozi
tips, and open-end
wrenches
Standard tool
Preventing Electrostatic Damage
Electrostatic discharge (ESD) can damage components in the instrument. To
prevent, ESD:
Do not touch exposed components or connector pins unless you are using
ESD protective measures, such as wearing a properly grounded antistatic
wrist strap.
Handle boards and modules little as possible.
Do not slide boards or modules across work surfaces.
Transport and store boards and modules in a static-protected bag or container.
Removal Procedures
NOTE.
Unless directed otherwise, installation is the reverse of the removal
procedure. Note cable routing when disassembling so that you can route the
cables correctly during assembly.
NOTE. The instrument does not require calibration after removal and replacement
of the indicated parts.
H600 & SA2600 Service Manual 4–3