Tektronix H600 RFHawk, Service Manual

Page: 101 / 109

Speci fi cations
This section lists the electrical, environmental, and physical speci fi cations for the
H600 and SA2600 Spectrum Analyzer. All speci fi cations are guaranteed unless
labeled “Typical.” Typical speci fi cations are provided for your convenience and
are not guaranteed.
Table 6-1: General performance characteristics
Characteristic Description
RF Input
Operating
Frequency
Range 10 kHz – 6.2 GHz
Operating Range for some features may be restricted. If so, the
restricted range is de
fi ned with the relevant feature.
Maximum
Operating
Input Level +20 dBm peak envelope power
This is the maximum input level at which the instrument will meet its
performance speci
fi cations.
For a signal without any amplitude variation, peak envelope power
= RMS.
Maximum
Input Power
without
Damage 50 W rms below 3.2 GHz
15 W rms between 3.2 GHz and 6.2 GHz
IF Output
Output
Impedance 50 Ω
IF Center
Frequency
140 MHz, non-inverted
IF 3 dB
Bandwidth 24 MHz nominal
IF Output Level –12 dBm @ 1.0 GHz
–12 dBm @ 1.2 GHz
–10 dBm @ 1.6 GHz
–11 dBm @ 4.35 GHz
–16 dBm @ 5.0 GHz
–22 dBm @ 5.75 GHz
0 dBm CW signal applied to the input, instrument reference level set to
0 dBm, room temperature.
IF Output Level
Accuracy, Typical ± 3.5 dB for a CW input signal, 0 dBm input, 1 GHz input frequency,
0 dBm reference level, room temperature
IF Output
Flatness, Typical ± 1.5 dB up to ± 3 MHz from center frequency
± 3 dB up to ± 10 MHz from center frequency
Internal Timebase
Error, Factory
Calibration
Corrected ± 0.5 PPM from 0 °C to 50 °C
± 1.0 PPM aging/year
Twenty minute warm-up period required to meet accuracy speci
fi cation
H600 & SA2600 Service Manual 6–1