Tektronix H600 RFHawk, Service Manual

Page: 21 / 109

Performance Veri fi cation
Performance Veri fi cation
This section enables you to verify that the instrument performs according to its
warranted characteristics.
Preparation
Before you perform the procedures in this manual, do the following steps:
Ensure that the procedures are performed only by quali fi ed service personnel
who have read the General Safety Summary at the front of this manual.
Ensure that the service personnel are familiar with system operation (refer
to the product user manual).
Obtain the equipment described in the following table. You may also need
additional cables and adapters, depending on the actual test equipment you use.
Description Minimum requirements Examples
Signal generator
0.009 to 6200 MHz,
phase noise better than
-110 dBc/Hz at 10 kHz offset
Anritsu MG3692B with
option 22 (low frequency),
option 3 (low phase noise,
main band), and option 4
(low phase noise, low band)
Frequency standard
10 MHz (or any frequency in
the range 1 MHz to 20 MHz
in 1 MHz increments), ±0.05
ppm Fluke 910/910R GPS
Controlled Frequency
Standards
Power meter with head 0.009 to 6200 MHz, -52 dBm
to +3 dBm Agilent E4418B
Agilent E9304A
Oscilloscope 300MHz band width Tektronix TDS3034B
10 dB fi xed attenuator 0.009 to 6200 MHz RLC Electronics A-8-10-N
50 ohm N-type RF cable 0.009 to 6200 MHz Florida RF Labs NMS -
290 AN - 36.0 - NMS
50 ohm BNC cables None Tektronix part number
012-0482-00
N-type barrel
female-to-female adapter 0.009 MHz to 6200 MHz SRI Connector Gage Co.
P/N 53-953-0003-00
H600 & SA2600 Service Manual 1–3