Tektronix H600 RFHawk, Service Manual

Page: 66 / 109

Removal and Replacement Procedures
1. Remove the fi ve screws from the battery compartment. Lift and pivot
the battery compartment towards the bottom of the instrument to access
connecting cables
When reinstalling these screws, torque them to 8 in/lb.
2. Remove the two screws and remove the battery connector board from the
battery panel chassis. Disconnect the cable that comes from the DC power
jack.
When reinstalling these screws, torque them to 8 in/lb.
CAUTION.
Do not remove the angle bracket with the foam thermal pad from the
battery panel chassis, as it is set to a speci fi c position.
3. Remove the two screws and remove the battery retainer hinge assembly.
When reinstalling these screws, torque them to 8 in/lb.
4. Remove the two screws and remove the speaker bracket.
4–8 H600 & SA2600 Service Manual