Teknor Industrial Computers PCI-993, Technical Reference Manual

Page: 156 / 204

VIP-UP Setup 16-1
16 VIP-UP SETUP
16.01 ACCESSING VIP-UP SETUP PROGRAM
The VIP-UP program is TEKNOR's own Setup program for enabling / disabling /
relocating various hardware features on the TEK933.
During boot-up, hit the CTRL and V keys simultaneously, before or when you see the
message "Press CTRL-V to enter TEKNOR VIP-UP" at the top of the screen (CTRL-V
will work, even if the message display is disabled in VIP-UP).
At the DOS prompt, type "VIP-UP" and press ENTER. This program is available on the
utility disk.
There are three screens in the VIP-UP program. The values appearing on the right side
of each screen can be modified. Follow the instructions found at the bottom of the
screen to select another value.
Use the
↑
and
↓
keyboard keys to move up and down the screen, and on to subsequent
or preceding screens. As you do, the value of the selected field is highlighted. If you
press the
↓
key when the last field of the screen is highlighted, the next screen is
displayed. Pressing the
↑
key when the first field is highlighted will display the first
field of the preceding screen; in this way you can move quickly from screen to screen.
Once a field value is highlighted, you can change it by pressing PgDn or typing "+" on
the keyboard (in VT100 mode, only "+" will work); this will usually display a higher
value. You can also press the PgUp key or type "-" ("-" in VT100 mode), which will
usually display a lower value.
Press F10 to save the current configuration and exit (type "U" in VT100 mode). The
configuration is not saved until F10 is pressed or "U" is typed. Press ESC to exit
without saving the setup.