Tegam 1830A, Instruction And Service Manual

Page: 40 / 66

10 TEGAM WAY • GENEVA, OHIO 44041 440-466- 6100 • FAX 440 -466- 6110 • www.tegam.com
4-24
Section IV – Operating Instructions
Sensor Commands
This group of commands is used for adding, editing, and deleting cal factor tables stored in the
1830A.
Command Description
SENSORS LIST (Query)
SENSORS SELECT {Serial #} {Frequency}
{Units}
SENSORS ADD {Serial #} {Frequency}
{Units} {K Factor}
SENSORS DELETE {Serial #} {Frequency}
{Units}
SENSORS UPDATE {Serial #} {Frequency}
{Units} {K Factor}
Display the list of defined sensors for the
system. The list will contain the sensor serial
#, Frequency, Units, and K Factor.
Loads a specific cal factor table to be used by
the 1830A
Add a new sensor to the list of sensors in the
system
Delete a specific sensor from the system
Update the K Factor value for a specific sensor
Table 4.2 - Model 1830A Sensor Commands
Front Panel Commands
These commands are used emulate the front panel of the 1830A. These commands would be
used if not directly in front of the device or external application automation.
Command Description
FRONTPANEL UPDATE
FRONTPANEL MENU
FRONTPANEL UP
FRONTPANEL DOWN
FRONTPANEL LEFT
FRONTPANEL RIGHT
FRONTPANEL FUNC1
FRONTPANEL FUNC2
FRONTPANEL FUNC3
Return an ASCII representation of information on the LCD
front panel of the device.
Simulate a front panel menu button click
Simulate a front panel up button click
Simulate a front panel down button click
Simulate a front panel left button click
Simulate a front panel right button click
Simulate a front panel function key 1 click
Simulate a front panel function key 2 click
Simulate a front panel function key 3 click
Table 4.3 - Model 1830A Front Panel Simulation Commands