40
www.teejet.com
Aeros 9040 Field Computer
►Connection Point In-line Offset Direction
– define the
direction as
Forward
or
Backward
based on ISOBUS Sprayer
connection type
►Connection Point In-line Offset Distance
– measured in
parallel to the centerline of the machine, define the distance
from the GNSS antenna to point
►Connection Point Lateral Offset Direction
– define the
direction, either left or right, from the centerline of the machine
to the center of point while facing in the machine’s forward
direction
►Connection Point Lateral Offset Distance
– define the
distance from the centerline of the machine to point
►Implement In-line Offset Direction
– same direction as Aeros
Connection Point In-line Offset Direction
►Implement In-line Offset Distance
– calculated based on
Aeros Connection Point In-line Offset Distance
and ISOBUS
Sprayer B=Section X-offset
entries
►
+
=
►Implement Lateral Offset Direction
– same direction as Aeros
Connection Point Lateral Offset Direction
►Implement Lateral Offset Distance
– same value as on Aeros
Connection Point Lateral Offset Distance
Figure 31: Front Mount
Figure 32: Rear Mount
– Center of the GNSS antenna
– Connection Point
– Connection Point In-line Offset Direction/Distance
– Connection Point Lateral Offset Direction/Distance
– B=Section X-offset distance
– Implement In-line Offset Direction/Distance
Trailed
ISOBUS Sprayer Settings:
1. Press UNIVERSAL TERMINAL bottom tab
.
2. From the Main setup screen , select
Machine
.
3. Select
OEM
then enter the access code as needed.
4. Select
Implement Geometry
:
5. Establish values for:
►Connector type:
Trailed
►A=Connection X-offset
– measured in parallel to the
centerline of the machine, define the distance from point to
the center of the front axle of trailed implement
►B=Section X-offset
– measured in parallel to the centerline of
the machine, define the distance from the center of the front axle
of trailed implement to the implement
Aeros Settings:
1. Press SYSTEM SETUP bottom tab
.
2. Press CONFIGURATION side tab
.
3. Press
Implement
.
4. Select Implement type
Straight
.
5. Press Implement type NEXT PAGE arrow to set up specific
implement options.
6. Establish values for:
