17
98-01504-ENUS R2
Aeros 9040 Field Computer
Application and Target Rate Maps
Application Map shows how much product has been applied
and where, using color to indicate level in proportion to preset or
automatically set maximum and minimum levels
Target Rate Map shows the application rate that the rate controller
attempted to achieve at each location
NOTE: Application map and Target Rate map cannot be selected
simultaneously.
Application Map
• Coverage area – illustrates applied area:
◄ User selected – applied areas show colored bars relative to
selected color range and map selection.
27.00
ac
10.0
mph
Mark A
Target Rate Map
• Coverage area – illustrates applied area:
◄ User selected – applied areas show colored bars relative to
selected color range and map selection.
27.00
ac
10.0
mph
Mark A
Target Rates
Preset target application rates define target rates of product being
applied per hectare/acre. These settings will set the same for all active
jobs.
Target rates are established on the ISOBUS ECU using the ISOBUS
UT. The current Target rate is selected and boosted using the ISOBUS
Operation screen on the UT. Boosting can also be controlled using the
Vehicle view screen
• Up to five (5) target rates can be established
Color Range Selection
Product options configure maximum/minimum rate limits and
corresponding display colors for mapping.
1. Press SYSTEM SETUP bottom tab
.
2. Press CONFIGURATION side tab
.
3. Press
Product
.
4. Select:
►Color Range – mode used to set the rate for Maximum rate color
and Minimum rate color.
◄ Automatic – maximum and minimum will be determined by
actual applied rate values or target rate values
◄ Manual – maximum and minimum limits will be set to those
set in Applied rate mapping upper limit and Applied rate
mapping lower limit options
►Maximum Rate Color – used to set the color for the maximum
rate. When in Manual Color Range mode, this color will be used
for all rates above the Applied Rate Mapping Upper Limit
►Minimum Rate Color – used to set the color for the minimum
rate. When in Manual Color Range mode, this color will be used
for all rates below the Applied Rate Mapping Lower Limit
Figure 19: Product Options
