Tecnam P2002-JF, Flight Manual, Page: 402 / 435

Page A14-28
Section 4 – Normal Procedures (Additional Controls)
Checklists
3
rd
Edition, Rev. 0
7. Practice Take-off and landing patterns.
It is recommended to perform specific training for take off, approach and landing
patterns at all flap settings. First approaches shall be interrupted at safety altitude
and go around practice shall be done as well.
Later on, touch and goes can be planned and executed by mean of hand controls
solely.
Training is also suggested for en-route phase of flight, coordinated turns, climbs,
power settings and flap configuration changes, climbing turns.
Typical tolerances to be obtained during training might be:

Airspeed: ±5kias

Sideslip: ±1/2 ball on slip indicator;

Engine: ±100rpm;

Spot Landing: ±5mt from centreline, ±25mt longitudinal error;

Taxi: ±1mt from taxiway centreline