C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 37 of 43
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: [email protected]
www.technolog.com
DMR No.: 7504
2099PM9000 Rev. B
Entering the enclosure
Notes
This operation must only be carried out in a clean, and dry, environment by suitably trained, competent, personnel in
accordance with the applicable code(s) of practice.
Prior to opening, the unit is to be thoroughly cleaned with clean water - refer to the "Cleaning" section at the beginning
of this document for further details.
Where a tamper-evident label is fitted to the unit, it must first be ensured that the necessary permissions are in place
to allow entry before proceeding!
•
•
•
Be aware that to prevent the
ingress of moisture and debris
the lid must not be left off any
longer than is absolutely
necessary!
Step 3
Carefully prise the lid off
using the moulded 'tab'
Step 1
Where a 'tamper-evident' label
is fitted, and after ensuring the
necessary permissions are in
place to enter the unit, it is
either to be slit or completely
removed
Step 2
Using a torque driver
with the correct screw
driver bit, unscrew
the four lid screws
and washers (be
aware that tamper-
proof 'allen' head
types are usually
fitted)
Step 4
Allow the lid to hang over
the edge of the base
DO NOT disconnect
the antenna cable!