AutoGRAPH-NAVIGATOR • USER MANUAL
13
TechnoKom © 2015
•
If necessary, insert a second SIM card in the holder intended for the backup SIM card
, i.3). Be sure that the SIM card is inserted into the retaining slot with its cut angle
facing the edge of the printed circuit board (
•
When the SIM cards are connected, place the removable panel back.
AutoGRAPH-NAVIGATOR starts operation with the main SIM card. If the main SIM card is unavailable
(disabled, damaged or not inserted), the device will switch to the backup SIM card.
i
NOTE
MicroSD card installation
AutoGRAPH-NAVIGATOR supports connection of a microSD card with capacity up to
32Gb. The device external memory is used to store firmware files, maps, task files and etc.
AutoGRAPH-NAVIGATOR is supplied with 4Gb microSD card.
BEFORE THE INSTALLATION
The SD-card, supplied with the device, contains all files required for the proper operation of
the AutoGRAPH-NAVIGATOR device.
Load all necessary maps in the device SD-card. All maps must be located in the folder
\AGMap of the SD-card.
SD-CARD INSTALLATION
MicroSD card slot is located on the device right side panel.
To install SD card in the device:
•
Ensure that the AutoGRAPH-NAVIGATOR device is turned off.
•
Insert a microSD-card in the slot with the card’s contacts upward (
Fig.2).
To remove the microSD card, gently push the card’s external edge and release it. Then
remove the card.
Specify PIN code of all device SIM cards in the device settings before you turn on the device. Use the
configuration application «AGNavConfig» to configure the device (for detailed information see section
«Device configuration» of this User Manual).
IMPORTANT
Do a test of a new SIM card in a cell phone before you install it into the device. This ensures that GPRS
/ SMS / USSD services are enabled and operate properly, the PIN code matches the code preset in the
device (in order to prevent locking), and a personal account associated with the SIM card has the
sufficient balance for successful operation of the services.
IMPORTANT
