AutoGRAPH-NAVIGATOR • USER MANUAL
14
TechnoKom © 2015
Fig.2. SD-card installation.
External power connection
The AutoGRAPH-NAVIGATOR device is connected to the power supply source through the
interface cable supplied with the device. Also the device is supplied with power adapter-
bracket intended to connect the device to power source using the interface cable. The power
adapter-bracket is also used to mount the device on the windscreen holder.
To connect external power to the device:
•
Mount the power adapter-bracket on the back side of the device. Ensure that the contacts
on the inside of the power adapter-bracket match the power contacts on the device.
•
Connect the interface cable supplied with the device, to the vehicle power source. When
making connections, pay special attention to the safety rules stipulated by the regulations
for motor vehicle repair procedures. All connections should be properly isolated and securely
connected.
•
Connect the interface cable to the interface connector of the power adapter-bracket.
•
The AutoGRAPH-NAVIGATOR device starts operation immediately after the power
connection. The device start-up window is given on
Fig.3. Start-up window.
