Technogym SYNCHRO Excite +, Service And Maintenance Manual

Page: 134 / 196

SYNCHRO : Service & maintenance manual - rev. 7.1
Page 7.36
7.11. DISASSEMBLY THE PRIMARY SHAFT AND PULLEY
Figure 7.11-1
Carry out the operations described in
paragraph: 7.7.1. “Rear guard”.
For remove the pulley on both levers:
1.
Back off the screw (a) , with a 10mm
hexagonal wrench, looking it on the opposite
side.
ATTENTION: During reassembly,
lock down the screws (a) using a
torque wrench setting of 9Nm.
Figure 7.11-2
2. If necessary replace the bearing (b) removing
the internal snap-ring (c) .
Figure 7.11-3
3. Back off the screw (d) that looks the bars (e)
with a small extractor, as shown in the figure
at the side.
Continued in following page...