Technogym JOG EXCITE, Service Maintenance Manual

Page: 101 / 126

JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 9.7
Press the
ENTER
key to change the parameter: when the current parameter value starts to blink,
press the
CLEAR
key to erase the current value and then use the number keys to enter the desired
new value.
Press
ENTER
to confirm the selection; use the
+
or
–
speed keys to move to the next or preceding
parameter.
The default value of this parameter is 5.0 km/h
The minimum threshold speed for the user detect function is 3.0 km/h. Entering any
value lower than this will have the effect of disabling the user-detect function.
If the unit of measurement is setted to IMPERIAL units (miles / pound), the default
value for this parameter is 3 mph while the minimum speed is 2 mph.
At the end of the format procedure, hold down the
CLEAR
key for a few seconds to exit. The
CLEAR
key can be pressed at any time to interrupt the procedure and revert to standby mode.
9.1.18. SN
This parameter shows the serial number of the machine.
9.1.19. R
EADY
2R
UN
It is possible to set how many time (in minutes) before the end of the exercise, the green light on the
handlebar, should starts blinking to indicate the soon end of the exercise. Ready2Run function is
managed in minutes, with values ranging from 0 to 5. To change the setting, when the LED matrix
shows the current time:
Ready2Run (min): xxx
Press the
ENTER
key to change the parameter: the current value of the parameter will start to
blink, at this point press the
CLEAR
key to erase the current value and then enter one digit at a
time using the
↑
and
↓
keys to change the value and the +/-
GOAL
keys to scroll to the next
character.
Press
ENTER
to confirm the changes made, and use the
+
or
–
speed keys to move to the next or
preceding parameter.
The default value of this parameter is 1.
Setting “0” this parameter will have the effect of disabling the function.