Menu Network
39
MENU Network
This menu contains all of the information and settings needed to set up a CANopen network.
Entire menu view:
Node No.: 1
The device has network address 1
ENABLE: ON
Participation in bus communication admissible
Autooperat.: yes
Device communicates with other bus participants without master
Status: operat
and is active
OUTPUT VARIABLE:
DIGITAL:
ANALOGUE:
Transmission cond.:
INPUT VARIABLE:
DIGITAL:
ANALG.:
Timeouts:
DATALOGGING
NETWORK NODES:
Node No
. - Each device in the network must be allocated its
own
address (node number 1-62)
Enable
- Without network release
ON
, the device cannot send or receive messages; it would
thus not be able to take part in communication.
Autooperat
. - If the network only consists of devices from the UVR1611- family (UVR1611,
CAN monitor, C.M.I., etc.), autooperat. must be set to
yes
(normal case). If there is a master
or network manager in the network
,
autooperat. must be set to
no
.
Status
– Autooperat. is set to
yes
, the status automatically switches from
init
→
pre-
op(erational)
→
operat(ional)
after the controller is started according to a preset procedure.
Only then is communication possible. If there is a bus master, it will switch the nodes to
opera-
tional
.
