Installation instructions
102
Installing the device
WARNING!
Always pull the mains plug before opening the casing!
To open the console the control unit
has to be separated from it as
follows:
Use two big screwdrivers to remove
the clamps (labeled 1 in the sketch
to the left) and list the device out of
the console with the screwdrivers.
Once the control device has been
removed, unlock the clip by pushing
with a small screwdriver (point 2
sketch left), flip the lid up and to the
back, and remove it.
Attach the console at eye-level
(approximately 1.6 meters high) to
the wall using the installation mate-
rial provided so that the cable out-
puts are at the bottom. The console has a separate lead for each power supply cable. The very fine
separation bridges sometimes break when the openings are popped out. As each power cable will
later have its own strain relief, this is not a problem.
Drawing:
Control cabinet version UVR1611S:
The opening in the cabinet must have a size of at least 138x91 mm; the insertion depth is 70 mm
including the power strips.
