SAS UG 202205-01
11
HARDWARE KIT FOR THE SAFETY ARM
The hardware (stainless steel screws, nuts and caps) are provided for the
installation of the Standard Surface Base on the upper plate.
1.
2 stainless steel screws 10-32 x 1-3/4” Philips (star)
2.
2 stainless steel screws 10-32 x 1-1/4” Philips (star)
3.
4 stainless steel hexagonal nuts 10-32 x 3/8”
4.
2 stainless steel hexagonal Caps 10-32
PRODUCT OPTIONS AVAILABLE
1.
The yellow color is the standard color for the Safety Arm System.
2.
Straight and Angled arm models for left and right side of the stretcher are available for additional configuration
options.
3.
To install the IV Pole on the same side of the Safety Arm Stretcher, an IV Pro Adapter plate is required to support
it. Contact Customer Service for more information,
INSTALLATION RELATED TO THE STRYKER POWERLOAD STRETCHER
9
The spacer block is the shim installed under the “V” bracket on the cot/stretcher frame when a power load system
is installed with the cot/stretcher. This bracket is NOT a Technimount part.
Introduction