50
SAS UG 202205-01
Maintenance Guide
CLEANING THE SAFETY ARM SYSTEM
CLEANING PROCESS
The Safety Arm System can be cleaned by using a pressure washer. The unit may show some signs of oxidation or
discoloration from continuous washing, however, degradation of the cot/stretcher’s performance or functionality will
not be affected due to power washing if cleaning instructions are properly followed.
The material used to manufacture the Safety Arm System is 6061-T6 Aluminum, it is very durable and resistant to
corrosion, however high levels of sodium or a high concentration of sodium or acid may prematurely corrode the
product. Always rinse with soft soap and water if exposed.
9
Use of a power washer can accelerate removal of contaminants collected during the use of the product.
9
Rinse with clean water.
9
Towel dry all casters and interface points, inside the triangle head and clamp block.
9
Allow all other components to air dry.
9
Avoid over saturation and ensure that the product does not stay wet longer than the cleaner manufacturer’s gui
-
delines for proper disinfecting.
WARNING
9
When cleaning, always use appropriate personal protection equipment (PPE) based on established protocols (e.g.,
gloves, eye wear, etc.).
CAUTION
9
Do not steam clean or use ultrasonic cleaners on the system or any of its components.
9
Do not immerse the metal parts/components in water.
9
Maximum water temperature should not exceed 180°F/82°C
9
Maximum water pressure should not exceed 1500 psi/103.5 BAR . If a pressure washer is being used to clean the
unit, the pressure nozzle must be kept a minimum of 24 inches (61 cm) from the unit.
CLEANING SOLUTIONS
Phenolic type or quaternary type disinfectants can be used (excluding Virex® TB). Iodophor type disinfectants,
Peracetic Acid, Chlorine, and especially Peroxide Oxygen are not recommended for use because staining and corrosion
may result.
Suggested cleaners for the Safety Arm System surfaces and clamp box:
9
Quaternary Cleaners (active ingredient - ammonium chloride)
9
Phenolic Cleaners (active ingredient - o-phenyl phenol)
9
Chlorinated Bleach Solution (3.25% - less than 1-part bleach to 100 parts water)
