6-1
EO18-33003A
6. DIAG. TEST OPERATION
6. DIAG. TEST OPERATION
6.1 OUTLINE OF THE DIAG. TEST OPERATION
6.1.1 When using the KB-80-QM optional keyboard
In system mode the diag. test operation is used to diagnose the printer and to set the parameters by using
the [F1], [
↑
], [
↓
] and [
→
] keys on the operation panel. Diag. test operation is started from the power off
state. For further details, please refer to the corresponding pages.
NOTE: Every size in this manual is written in millimeter. To obtain the size in inch, divide by 25.4.
6.1 OUTLINE OF THE DIAG. TEST OPERATION
■
Self Test Mode (See page 6-3)
Data from the maintenance counter and
automatic diagnosis are printed on the
paper. The result of the head broken element
check is indicated in the display.
■
Parameter Setting Mode (See page 6-11)
Fine adjustment of the feed length, cut/strip
position, reverse feed, X axis, print tone and
the threshold of the black mark sensor and
the feed gap sensor, selection of character
font, font zero, strip wait status,
communication mode and the language of
LCD message, and feed speed adjustment
are available in this mode.
■
Test Print Mode (See page 6-38)
Print condition and test print type (slant lines,
characters, and bar codes) are selectable.
■
Sensor Setting Mode (See page 6-47)
A thermistor check and the setting of the black
mark and feed gap sensors are available in this
mode.
A transmission check is made to both a print
head thermistor and an environmental
temperature thermistor.
■
RAM Clear Mode (See page 6-49)
Data from the maintenance counter is cleared
and parameter setting is initialized in the RAM
clear mode.
■
LAN I/F Setting Mode (See page 6-54)
Each parameter setting of the LAN I/F is
available in this mode. (This mode is valid
when the LAN I/F board is installed into the
printer.)
< 1
D I A G . V 1 . 1 A
>
< 2
P A R A M E T E R
S E T
>
< 3
T E S T
P R I N T
>
< 4
S E N S O R
A D J .
>
< 5
R A M
C L E A R
>
< 6
L A N
I / F
>
S E T
Press the [
↑
] key.
Press the [
↓
] key.
Turn on the power while
holding down the [SHIFT]
key.
Power off
Press the [
↑
] key.
Press the [
↑
] key.
Press the [
↑
] key.
Press the [
↑
] key.
Press the [
↑
] key.
Press the [
↓
] key.
Press the [
↓
] key.
Press the [
↓
] key.
Press the [
↓
] key.
Press the [
↓
] key.
NOTE: The parameter setting for each mode is displayed on the second line.
