3-19
EO18-33003A
3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
10) Fit the strip sensor cover to the four holes in the right side of the printer.
Fig. 3-38
Hole
Hole
Strip Sensor Cover
Notch
Paper Guide Base
Strip Seneor Cover
Strip Sensor Harness
NOTES: 1. After inserting the strip sensor
harness into the notch, return
the paper guide base (TS
model) or sensor block (HS
model) which was removed in
STEP 6 to the printer.
2. After reassembling the sensor
block in the HS model, check
for a smooth adjustment of the
media sensor position. If the
strip sensor harness is
entangled in the media sensor
harness, a smooth adjustment
cannot be performed. Refer to
STEP 7 and lead the strip
sensor harness again.
Platen
(Revision Date: Jan. 23, 2001)
3.7 STRIP MODULE (B-7904-H-QM)
Fig. 3-39
Ground Wire
Cable Clamp DKN-5
Cable Clamp MSC-1
Strip Sensor Harness (Black)
11) Lead the strip sensor harness (black) and the ground wire under the platen, and then fix them
with the cable clamp MSC-1 and the cable clamp DKN-5.
Strip Sensor
Harness
