22
23
PREPARATION
General Battery Precautions
CAUTION
- Do not attempt to charge a fully charged battery pack. Doing so, may shorten the life-
time of the battery pack or the battery pack may get damaged.
- Upon completion of charging process, disconnect the battery pack from the charger.
If the charger power is reset (turned ON after being turned OFF), recharging will start
again and the battery pack will be over-charged.
- Do not use the transceiver while charging the battery pack. We recommend to switch
the transceiver power OFF during charging.
- Do not expose the battery pack to heat or fire.
- Never attempt to remove the casing from the battery pack.
DANGER!
- Do not disassemble or reconstruct the battery pack!
The battery pack has a safety function and protection circuit to avoid danger. If they
suffer serious damage, the battery may generate heat or smoke, rupture, or burst into
flame.
- Do not short-circuit the battery!
Do not join the + and - terminals using any form of metal (such as a paperclip or wire).
Do not carry or store the battery pack in containers holding metal objects (such as
wires, chain-necklace or hairpins). If the battery pack is short-circuited, excessive cur-
rent will flow and the battery may generate heat or smoke, rupture, or burst into flame.
It will also cause metal object to heat up.
- Do not apply heat to the battery!
If the insulator is melted, the gas release vent or safety function is damaged, or the
electrolyte is ignited, the battery may generate heat or smoke, rupture, or burst into
flame.
- Do not place the battery near fires, stoves, or other heat sources!
If the polymer separator melts due to high temperature, an internal short-circuit may
occur in the individual cells and the battery may generate heat or smoke, rupture, or
burst into flame.
- Do not immerse the battery in water or get it wet by other means!
If the battery's protection circuit is damaged, the battery may charge at extreme cur-
rent (or voltage) and an abnormal chemical reaction may occur. The battery may gen-
erate heat or smoke, rupture, or burst into flame.
- Do not charge the battery near fires or under direct sunlight!
If the battery's protection circuit is damaged, the battery may charge at extreme cur-
rent (or voltage) and an abnormal chemical reaction may occur. The battery may gen-
erate heat or smoke, rupture, or burst into flame.
- Use only the specified charger and observe charging requirements!
If the battery is charged in unspecified conditions (under high temperature over the
regulated value, excessive high voltage or current over regulated value, or with a
remodeled charger), it may overcharge or an abnormal chemical reaction may occur.
The battery may generate heat or smoke, or burst into flame.
CTCSS
DCS
Dual Band
Reverse Frequency
Split negative
Split positive
VOX
Battery Capacity Indicator
Bandwidth Indicator
Receive Signal Vice Frequency
Key Lock
Receive Signal-Meter
Busy Channel Lock
High / Low Tx-Power
Receive Signal-Meter
Receive Signal-Meter
Switch Master
Frequency Indicator
(16) PTT (Push-To-Talk) key
(17) PF1 - Side Key 1 :
Scan / Lamp /
SOS-CH / Radio
(18) PF2 - Side Key 2 :
long press : monitor
short press: flashlight
(20) Speaker /
Microphone Jacks
(21) Battery Latches
LCD Display
English
English
tecom-db_manual_amend_ham.qxp 11.12.2009 14:01 Seite 22