USER GUIDE
/// ENTRELEC TERMINAL BLOCKS - HTP600 THERMAL TRANSFER PRINTER ///
412-121040 REV 1
21
POWER SUPPLY CABLE CONNECTION
Make sure that the printer power switch is off (0).
1) Connect the power cord to the power cord socket on the rear of the printer.
2) Plug the other end of the power cord into the power outlet (100V to 240V AC).
WARNING
Take care to follow carefully the safety instructions set forth in chapter 1.3.
Do not connect the printer to a power source that provides other than the rated voltage (100V
to 240V AC, 50/60Hz). Using any other voltage could cause a fire or electric shock.
Do not pull the power cord when it is connected to the power cord socket on the rear of the
printer or otherwise apply undue force to the power cord connector. Doing so could damage
the wiring and cause a short, fire, or electric shock.
When unplugging the power cord from the power outlet or the socket on the rear of the
printer, always grasp the plug or connector.
USB CABLE CONNECTION
Make sure that you are using an USB interface cable compatible with your PC.
1) PC and printer should be turned off.
2) Connect the USB cable at the rear of the printer.
3) Connect the other end of the USB cable on the PC
REMIND
The printer is supplied with just a USB Port.
WARNING
Make sure to use a printer cable IEEE-1284 of length less than 2m so to avoid any kind of
disturbs or radio interference.
Follow the instructions below reported so to avoid electrical shock.
1) Turn off the printer and unplugged the socket from the wall power
2) Turn off the PC and unplugged the socket from the wall power
NOTICE
This equipment has been tested to comply with EMC Directive technical requirements. Shielded
cables have to be used in compliance with EMC Directive technical requirements.
