USER GUIDE
/// ENTRELEC TERMINAL BLOCKS - HTP600 THERMAL TRANSFER PRINTER ///
412-121040 REV 1
62
PRINTER MESSAGES / ERRORS
If the print is in progress and one of these messages appears on
HTP600
display, proceed as
follows:
WRITING PROBLEMS
The print stops before the plate end
Verify that the driver is set the correct print area. For Ex., if in the driver it has been set for a
print area of 80mm x 50mm the prints will stop after 50mm.
After having launched a print, the plate passed over and no print is on it
This is a problem of non-correct software settings.
1) Verify that all the driver’s settings are correct. See the quick installation user’s guide into the
HTS600 software file for the appropriate configurations.
2) Verify the centring and the calibration from the HTS600 software in particular:
2.1)
It might be inserted a centre value to high and this can move the print out of
the print area.
2.2)
A calibration value might be inserted to high and this can move the print out of
the print area.
For both problems delete from the HTS600 software the installed printer device and repeat the
centering and calibration operations.
After having launched the print the plate stack doesn’t move
This problem depends on the non-correct position of the red cleaning roller.
Verify that the red cleaning roller is perfectly positioned and fixed on its right position.
The prints looks faint and too heavy
1) Verify that all the driver settings are correct.
See the quick installation user’s guide into the HTS600 software file, for the appropriate
configurations.
2) Verify that the red cleaning roller is clean. Make a clean of the cleaning roller and try to
print.
3) Increase the density value from the driver settings. This value can go from 1 to 5.
The prints of Cable and Terminal Tags is not continuous and homogeneous
1) The item’s step is not maintained.
2) Some texts are horizontally cut.
Verify that the encoder beneath the support plate for cable and terminal tags is not damaged
and is clean.
If some lines of the encoder are not read it, the head print will lift-up and will not write.
