TE HTP600, User Manual

Page: 15 / 69

USER GUIDE
/// ENTRELEC TERMINAL BLOCKS - HTP600 THERMAL TRANSFER PRINTER /// 412-121040 REV 1
15
Power Supply
Remember every electrical equipment can cause injury if not handled properly.
Make sure you observe the following warnings and cautions to prevent accidents and injuries.
WARNING

If the printer begins working not properly, emitting smoke or strange smells, turn it off
immediately, unplug the power cord and contact TE Technical Assistance

Never handle the power cord with wet hands

Don’t use multi socket adapters to plug more than one device into one single plug

Make sure that the power cord is properly plugged in

Don’t put the power cord close to a heat source

Never attempt to disassemble or modify the printer

Before cleaning the printer, always turn it off and unplug the power cord

When cleaning the printer, dampen some gauze and wash it out thoroughly. Do not use
flammable solvents, such as alcohol, benzene or paint thinner.
External Cleaning of the Printer
Always clean the printer when it is turned off and not plugged to Power. Use a dry cloth or a little wet
with water. Do not use flammable liquids.
Use and Maintenance
Failure to follow the warnings and cautions described below during use and maintenance of the
printer could result in accidents, fire, electrical shock or burns.
WARNING

Don’t touch the print head immediately after printing

Don’t use this printer and its accessories for any purpose other than the one designed for
CAUTION

Use only the ribbon cassette on equipment. Never attempt to disassemble the ribbon
cassette to place another ribbon inside the cassette

Do not pull the plate or sheet while print is in progress

Do not expose HTP600 to direct sunlight, high humidity or dust. Use and store the printer and
its accessories respecting the environmental conditions listed below:
WARNING

Don’t connect the printer to a power source that provides other than the rated voltage:
100÷240 V AC, 50/60Hz

If some foreign material (a piece of metal, some water or some other liquid) gets inside the
printer, turn the power off immediately, unplug the power cord and contact TE Technical
Assistance

While unplugging the power cord, always grasp the plug, not the cord. Pulling the cord could
damage it

If the printer is not going to be used for a long time, unplug the power cord. If the cord is not
unplugged, that could result in an electrical leak.

It is always a good habit not to leave the cord plugged in for long periods of time anyway.