TB Wood's WFC1000 Series, Installation, Operation And Maintenance Instructions

Page: 12 / 82

4
Model Series WFC1000 WFC2000 WFC4000
Programming Levels Level 1 – Operator Level 2 – Engineer 25, 43
Level 3 – Engineer with SIO
Parameter Block 00 Model #, software revision, rated current, heat –
Drive Data sink temp. trip point, mfg. serial #, repair
date code, & fault log.
Parameter Block 10 Output frequency, voltage, motor current, motor load, –
Status torque, drive temperature, elapsed time since power
applied, & total hours of operation.
Parameter Block 20 Definition of the LOCal/REMote keypad button in –
Control reference to the keypad, terminal strip, & the SIO link.
Also, various speed and torque references are
contained within this block.
Parameter Block 30 Various speed setpoints of the inverter. –
Frequencies
Parameter Block 40 Ramp time selections (the time from start –
Ramps to maximum frequency FMAX or
from FMAX to stop)
Parameter Block 50 V/Hz curves, boost, minimum frequency at –
Voltage/Frequency full voltage, & skip frequencies.
Characteristics
Parameter Block 60 Torque limit setpoints, slip compensation, overload –
Torque Limit trip point, & auto-restart parameters.
Parameter Block 70 METer output, open collector output, & –
I/O Definition fault relay definitions.
Parameter Block 80 Storage & Retrieval of standard or custom programs, –
Program Options complete reset to factory settings, auto-restart, line
start lockout, PWM selection, display of engineering
units, alternate display languages, & customer
access code storage.
Parameter Block 90 BAUD or communication rate, slave address, watch- –
RS485 Serial Link Options dog timer, & retrieval of SIO generated fault codes.
Parameter Block A0 Speed Ratio & various parameters relative to the –
Option Parameters calibration of WPC option cards
Parameter Block B0 Option Board Identification and various parameters –
Option Parameters relative to the calibration of WPC option cards
Parameter Block C0 Used with program sequencer to 35
Event Control Bytes control drive operation
Parameter Block E0 Used with program sequencer to 35
Event Count Bytes control drive operation
Chassis, NEMA 1, NEMA 4 NEMA 4 standard thru 50/60 HP –
Chassis/NEMA 1 In separate enclosure protected from dust, 7
moisture and corrosive fumes.
NEMA 1 Indoor protected from dust, moisture and corrosive fumes 7, 17
NEMA 4 Indoor protected from direct sunlight 7, 17
Operating Temperature Chassis – 0° C to 50° C NEMA 1/4 – 0° C to 40° C –
Storage Temperature -20° C to +60° C –
Humidity 90% RH or less, noncondensing (chassis controls) –
Vibration 0.6 G Maximum –
Elevation Less than 3,300 feet without derating –
See
Page
Programming
Construction
Mounting
Location
Ambient
Conditions
TABLE 1.4 (Con’t.)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com