TB Wood's WFC1000 Series, Installation, Operation And Maintenance Instructions

Page: 11 / 82

3
Model Series WFC1000 WFC2000 WFC4000
Torque Limit Deceleration Programmable – 0.1 to 30 Seconds 29
Rate
Minimum Frequency in Programmable – 0.5 to 400 Hz 29
Torque Limit
Torque Boost Programmable to suit requirements plus Autoboost 30
Dynamic Braking 30-200% of drive rating (10 sec. max.) standard –
Consult factory for model specific data.
Additional capacity available by adding external DB kits.
Adjustments Over 100 parameters can be monitored with –
over 80 user adjustments
PWM Frequencies Two settings available 39
Agency Listing UL ® and cUL ® Listed; CE Marked –
Charge Indicator Indicates the presence of potentially lethal bus voltage 15
Ground Fault All models fully protected –
Output Short Circuit All models fully protected –
(Line-to-Line)
Electronic Motor Overload Programmable Inverse Time Overload Trip 32, 33
Overvoltage Trip Level 407 VDC 815 VDC –
(on DC bus)
Undervoltage Trip Level 180 VDC 400 VDC –
(on DC bus)
Torque Limit 4 Quadrant – Independently Programmable 28, 31
Program Lockout User definable security access code 42
Line Start Lockout Prevents automatic startup when line power 39
is applied (defeatable by programming)
Overtemperature Drive will shut down if heat sink temperature –
exceeds rating
DB Failure Drive will sense circuit failure and shut down –
Error/Fault Messages 19 fault codes 53
6 warning displays
Fault Storage Last three (3) faults stored. Most recent displayed. 25
Line Transient Limit 2 KV. Maximum (less than 40 microsecond duration) –
External MOL Contact Compatible with NC fault contact 17
Operating Controls 1. Keypad: Forward, Reverse, Jog, Stop, Program, 18
Shift, Enter, Local/Remote and Up/Down Arrows.
2. Terminal strip: See typical connection 16
diagrams or consult factory.
3. RS485 Serial Input/Output (SIO) Link. 43
LED Indicators Forward, Reverse, Jog, Stop, Bus Charged 20
and CPU Active
Display 2 – lines of 16 characters, Back-Lit
alphanumeric for all modes of operation.
Programmable to display in English, French, 21, 40
Spanish or German.
Any engineering units such as RPM, FPM, &
GPM are supported.
Auxiliary Relay Programmed as Fault Relay. Can be 17, 34
programmed to signal one of eleven conditions
See
Page
Control
Specifications
(continued)
Protection
Features
Operating
Features
TABLE 1.4 (Con’t.)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com