Taurus Universal Smith Machine, Assembly And Operating Instructions Manual

Page: 26 / 60

26
Universal Smith Machine
Step 6: Assembly of the Weight Stacks
1. Slide one rubber cushion (47) over each of the four guide rods (48).
2. Insert the guide rods (48) into the left and right base frames (1 & 4).
⚠
CAUTION
Guide only one weight plate at a time over the guide rods.
L
NOTICE
Begin with the weight plate with the highest number and continue accordingly. Make sure the
numbers on the weight plates are oriented inwards.
3. Lightly tilt the guide rods (48) at an angle and guide the weight plates (45) over the guide rods
(48).
4. Guide the top weight plate (46) with the pre-assembled selector rod (49) over the guide rods
(48) and guide the selector rod (49) through the centre hole of the weight stack.
5. Secure the guide rods (48) to the frames (2 & 3) from the top with one bolt (50) and one washer
(11) each. Tighten the bolts (50) and cap with one plastic cover (14) each.
6. Insert one weight stack pin (101) into each weight stack and place the ring of the weight stack
pin (101) around the thread of the selector rod (49) protruding from the top weight plate.
࣑ ATTENTION
Each weight stack has a total weight of 100 kg. You have the option of increasing this additionally
with weight plates. For this, the selector rod with barbell holders (88) must be installed instead.
If you wish to do this, skip step 7 and continue with step 8 instead. Please note that you will not
be able to install the shields (58).
7. Screw the pulley bracket (100) into the
thread of the selector rod (49).
L
NOTICE
The pulley bracket (100) serves as a cable
adjustment point. The pulley bracket (100)
does not have to be completely screwed in,
but always at least 1/3.
8. Screw the selector rod with barbell holders
(88) into the thread of the selector rod (49).