Taurus Universal Smith Machine, Assembly And Operating Instructions Manual

Page: 22 / 60

22
Universal Smith Machine
Step 4: Assembly of the Upright Frames, Bearing Frames and Upright Boards
L
NOTICE
+ The pulleys on the bearing frames (25 & 26) should be oriented inwards.
+ The scales on the upright frames (21 & 22) should be oriented forwards and outwards.
+ Connect the components loosely first and tighten bolts and nuts only when all components
are connected. Then attach the plastic covers.
1. Slide the left bearing frame (26) onto the left upright frame (21) by pulling the T-pin and
engaging it in one of the adjustment holes.
2. Attach the left upright frame (21) to the top of the left frame (3):
2.1. From the side: With one bolt (84), one washer (11) and one plastic cover (14).
2.2. From the front: With one bolt (9), two washers (11), one nut (10) and two plastic covers (14).
3. Attach the left upright frame (21) to the left base frame (1) with one bolt (9), two washers (11),
one nut (10) and two plastic covers (14).
4. Repeat the steps 1 to 3 with the right upright frame (22) and right bearing frame (25).
5. Tighten all bolts and nuts and attach the plastic covers (14)
like shown.
L
NOTICE
Use only the bottom four holes for the
following step. The top hole must remain
free.
6. Attach the left upright board (23) to the
front strut of the left frame (3) with a total
of four bolts (12), eight washers (11), four
nuts (10) and eight plastic covers (14).
7. Tighten the bolts (12) and nuts (10) and attach
the plastic covers (14).
8. Repeat the steps 6 and 7 with the right upright
board (24).