Taurus Universal Smith Machine, Assembly And Operating Instructions Manual

Page: 24 / 60

24
Universal Smith Machine
Step 5: Assembly of the Guide Rods and Barbell Rod
⚠ CAUTION
The rods (33 & 27) are lubricated.
࣑
ATTENTION
The required rubber cushions (44) are slightly tapered and must be aligned according to the
following drawing:
1. Slide the components onto both guide rods (33) in the following order (33):
rubber cushion (44), safety hook (35 - left; 36 - right), rubber cushion (44) and bearing frame (37).
Place the guide rod lock sleeves (34) to the top of the guide rods (33).
2. Insert the left guide rod (33) and the respective components into the left base frame (1) and left
frame (3).
3. Attach the left guide rod (33) to the left frame (3) with one bolt (39).
4. First, slide the barbell rod (27) through the left sided bearing frame (37) on the left guide rod
(33), then hang the barbell rod (27) at any height in the upright boards (23 & 24).
5. While holding the right guide rod and its components, first slide the right sided bearing frame
(37) onto the right side of the barbell
rod (27), then insert the right guide rod
(33) into the right base frame (4) and
right frame (2).
6. Attach the right guide rod (33) to the
right frame (2) with one bolt (39).
7. Slide the rod end tubes (29) onto each
end of the barbell rod (27) and secure
with one bolt (43), one spring washer
(42) and one washer (41) each.
8. Attach the barbell rod rings (28) to the
rod end tubes (29).