18
Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
RC² 2600 CL / RC² 2600 LSL / RC² 3100 CL
Correct assembly
Aligned internal forks
Incorrect assembly
Unaligned internal forks
Set-up instructions
1/3
2/3
• It is important to give finish working in the cut parts.
For this purpose, use a filer. Soon after, remove the filing and
lubricate the 'male' with a fine layer of grease.
• Decrease the length of both protective covers, using the
cut tubes as a measure and clean the cut residues.
• When using another tractor to work with the rotary cutter,
verify the length of the cardan shaft again.
NOTE
• The chains of the protection covers should be fastened in the equipment and in the
tractor, so that they will not get loose during maneuvers.
• The correct cardan shaft
assembly is showed on the
figure. Observe the position
of the forks, being careful
when disassembling them. A
wrong assembly may cause
excessive vibration, damaging
the transmission.
• The contact surface between the hub and the bar shall not be smaller
than 1/3 of the total length.
