Tascam DR-701D, Reference Manual

Page: 37 / 46

TASCAM DR-701D
37
9 – Settings and Information
Adjusting the display contrast
While pressing and holding the MENU button, turn the DATA
dial to adjust the display contrast.
Setting the peak hold time
You can set the level meter peak hold time.
1. On the
METER/TRIM
page, select the
PEAK HOLD
item. (see “Menu operation procedures” on page 12)
2. Set the level meter peak hold time.
Options:
OFF
,
1sec
,
2sec
(default),
10sec
,
HOLD
(always shown)
3. When finished, press the MENU button to return to the
Home Screen.
NOTE
When the Home Screen is open, turn the
DATA
dial to reset
peak hold display.
Setting trim operation mute
You can set whether or not minimizing the 1/2/3/4 knob values
mutes or not when the Home Screen is in trim display mode.
1. On the
METER/TRIM
page, select the
TRIM MIN
item.
(see “Menu operation procedures” on page 12)
2. Set the trim curve.
Option Meaning
MIN
Minimizing the 1/2/3/4 knob values
does not mute.
MUTE
(default)
Minimizing the 1/2/3/4 knob values
mutes.
3. When finished, press the MENU button to return to the
Home Screen.
Making power management settings
You can make various power management settings on the
POWER MANAGEMENT
page.(see “Menu operation proce-
dures” on page 12)
Setting the type of batteries
Use the
BATTERY TYPE
item to set the type of batteries
used. This setting is used to show the amount of remaining
battery charge and determine if the unit has enough power for
normal operation.
Options:
ALKALI
(alkaline, default),
Ni-MH
(nickel-metal
hydride),
LITHIUM
(lithium)
Set the automatic power saving function
Use the
AUTO PWR SAVE
item to set the amount of time
from when the unit last operated or was used until the unit
automatically turns off (enters standby).
Options:
OFF
(unit does not automatically turn off),
3min
,
5min
,
10min
,
30min
(default)
Setting the backlight
Use the
BACKLIGHT
item to set the time until the backlight
automatically dims after the last operation when powered by
batteries.
Options:
OFF
(unlit),
5sec
(default),
10sec
,
15sec
,
30sec
,
ALWAYS
(always stays lit)
Restoring factory default settings
You can restore the various settings stored in the backup
memory of the unit to their factory default values.
1. On the
SYSTEM
page, select the
INITIALIZE
item. (see
“Menu operation procedures” on page 12)
2. Press the DATA dial.
A confirmation pop-up message appears.
3. Press the DATA dial to initialize the unit.
Press 1/
8
to cancel starting initialization.