Menus
Page C-4
Instruction Manual: Professional Receivers and Decoders (IRD)
ST.TM.TT1220.1
C.3
Setup Menu
C.3.1
Setup Menu Items
The setup menu contains all the submenus and items, required to set the
configuration and control the daily use of the unit.
Table C.2: Setup Menu Items
Display title: Setup
Description
Section
Demod>
Enters the demod submenu
C.3.2
TV Service>
Enters the TV Service submenu
C.3.3
TV Components>
Enters the TV components submenu
C.3.4
Video Format
Changes the default Video format:
“PAL”, “SECAM” or “NTSC” selectable
1
Subtitling
Activates EBU Teletext Subtitling, if available: “EBU” or “Off”
selectable.
Teletext
Activates Teletext insertion into the outgoing VBI, if available:
“On” or “Off” selectable.
Audio2 Service>
Enters the Audio2 service submenu
C.3.5
Audio2 Comp.>
Enters the Audio 2 Components submenu
C.3.6
Advanced>
Enters the Advanced submenu
C.3.7
C.3.2
Demod Menu
The demod menu contains all the items that need to be set, to achieve a
signal lock on an incoming QPSK transport stream.
Table C.3: Demod Menu
Display title: SET: DEMOD
Description
Section
LNC freq
Changes the LNC frequency in gigahertz.
Sat freq
Changes the satellite frequency in gigahertz. For a frequency to
be valid, the (Sat. Freq. – LNC Freq) should be a number
between 950 MHz and 2150 MHz.
Sym rate
Changes the Symbol Rate in megasymbols. Valid range is 1.000
to 44.500 Msym/s.
Inner code
Changes the FEC rate: “Auto”, “1/2”, “2/3”, “3/4”, “5/6” and “7/8”
selectable.
LNC volt
Defines the voltage output by the F-connector located on the
TT1220. “Off”, “13V” and “18V” selectable.
LNC 22kHz
If unit should provide LNC 22 kHz control signal to the LNB: “On”
or “Off” selectable.
Spec inv
Enables or disables spectrum inversion on the incoming signal:
“On” or “Off” selectable.
1
The Videoformat selection is not a format converter. The video format of the incoming MPEG stream will override this
setting.
