Operating the Equipment Locally
Page 3-4
Instruction Manual: Professional Receivers and Decoders (IRD)
ST.TM.TT1220.1
3.2.2
Selecting a (Sub)menu Item
Selecting the Menu Item
To select a menu item, navigate using the up and down button until the
desired menu is displayed in front of the cursor. Press the right arrow to
select / enter this menu item.
Leaving the Menu Item
To leave the current menu tree, press the left arrow button.
3.2.3
Editing a Menu Value
Accessing the Edit Mode
To edit a menu item, first select the item using the right arrow button.
This will bring you from the select mode to the edit mode.
Editing a Selectable Option
Once in edit mode, use the up or down button until the desired value is
displayed. Exit and save the selection by pressing the right button.
Editing an Alphanumerical Value
When editing an alphanumerical value, the cursor starts flashing
underneath the rightmost digit, once entering the edit mode. Use the up
and down arrow to increase or decrease the value of this digit. Press the
left button to select the next digit. You will see the cursor move to
underneath the neighbouring digit. Again, use the up and down arrow to
increase or decrease the value of this digit. Once satisfied with the result,
move the cursor outside the selectable digits, by using the right button
several times. Once the cursor moves outside the selectable area, the
buttons return to navigation mode, and the new value is saved.
3.3
Setting Up the Input
Setting Up the QPSK Input
Setting up the QPSK input is done entirely from the
demod
menu. Table 3.1
steps through all the necessary settings to achieve signal lock.
Table 3.1: Tuning the Satellite Receiver.
Step
Action
Result
1.
Go to the demod menu, located under
the setup menu.
The display will read “SET: DEMOD” on the top line.
2.
Repeat pressing the up arrow, until you
are on the top line
The display will read “LNC Freq.:” on the bottom line.
3.
Press right once, and then by using the
buttons as explained in Section 3.2.3,
Editing a Menu Value, enter the desired
LNC frequency.
The LNC frequency should be set to match your
external LNC.
