TallyGenicom 6600 Series, Maintenance Manual

Page: 89 / 474

List of Messages
89
LOADING PROGRAM
INTO FLASH The printer has deleted the
previous program from flash
memory and is loading the
new program into flash
memory. No action required.
NEW SPX DETECTED
PRESS ENTER The printer detects an SPX
in its debug port and the
SPX is valid for this printer. Press the ENTER key. The following
actions occur:
1. The SPX copies the printer’s
security key serial number into its
flash memory.
2. The printer reprograms its
security key with the information
stored in the SPX.
3. The printer verifies that the key
was programmed as intended.
4. The SPX overwrites itself so that
it cannot be used again.
NON VOLATILE
MEMORY FAILED Large emulations reduce the
amount of space available
for saving configurations,
which means that
sometimes fewer than 8
configurations can be saved.
If this message appears
when saving a configuration,
it means the printer is out of
memory. Previously saved
configurations will still be
available, but the one that
was “saved” when the
message appeared is not in
memory. If this message
appears at power-up, it
means the flash memory is
defective. 1. If the message appears at power-
up, replace the flash memory.
2. If the message appears while
saving a configuration, the printer
is out of memory and will not save
that or subsequent
configurations. (Previously saved
configurations are still okay.)
3. If the message appears after
replacing/increasing memory,
replace the controller board. (Do
NOT attempt to replace NVRAM.)
NOVRAM ERROR n Processor Halted message.
This error is most likely
associated with the V6 PSA3
Logic card. Follow the
corrective action steps to
resolve it.
Replace the controller board. (Do
NOT attempt to replace NVRAM.)
Record the message and return it
with the controller board.
Table 3. 6600 Error Messages List
Displayed Message Explanation Solution