TallyGenicom 6600 Series, Maintenance Manual

Page: 164 / 474

164
Chapter 4
Paper Out Adjustment
Paper Out Adjustment
This procedure tests and sets the distance from the page perforation at which
a LOAD PAPER fault message is triggered. This adjustment prevents printing
on the platen when the printer runs out of paper.
The measurement units are dot rows.
You will use the dot row patterns printed by the Paperout Adj. test to verify
that this parameter is set correctly.
NOTE: Do this procedure only if a new paper detector switch assembly has
been installed, the controller board has been replaced, or if you are
sure the paper out adjustment is incorrect. A paper out triggering
distance of 1 or 2 dot rows above the perforation is acceptable; 5 to 7
dot rows above or any dot rows below indicates adjustment is
required. Also, although it is not required, it is advisable to test the
paper out triggering distance with 6-part paper, in order to verify
correct printing with multi-part forms.
The procedure below describes how to run the Paperout Adj. test and modify
the paper out “Dots” value.
1. Open the printer cover.
2. On cabinet models, open the cabinet front door.
3. Load paper. Make sure the forms thickness lever is closed.
4. Power on the printer.
5. On the sheet of paper just below the paper entrance slot, cut or tear a four
inch square on the left side, immediately below the perforation.
(See Figure 14.) This creates a hole that will trigger a LOAD PAPER fault
message, but allows printing to the right of the hole (which would occur on
the platen in a true paper out condition).
6. Cut or tear a four inch square in the manner described above, on every
third sheet, until you have made 3 or 4 holes.
Figure 14. Paper Preparation for Paper Out Adjustment Test
Page Perforation
Cut out here
4 in.
4 in.