Electrical Controls
25
Controls and Indicators
Electrical Controls
Switch or
Indicator
Function
Active
Online
Active
Offline
Power Switch
Turns printer on and off: 1 = on, 0 = off. This switch is also a circuit
breaker.
Status Indicator
On when the printer is online, off when the printer is offline. Flashes to
indicate a fault or warning.
9
9
LCD
Liquid Crystal Display. Displays printer status messages, fault messages,
and menus which permit user to set various configurations.
9
9
ONLINE
Toggles the printer online and offline. Clears the printer after a fault is
corrected and returns the printer to offline state. Pressing CLEAR silences
the audible alarm (if enabled).
9
9
LF
Performs a line feed (LF - line feed). A single press of the LF key causes a
line advance.
9
9
FF
Performs a form feed paper advance (FF - form feed) . A single press of
the FF key causes a form advance to the top of the next form.
9
9
CLEAR
In a fault state this key attempts to clear the fault. When the fault is cleared
the printer returns to the offline mode.
When the printer is in offline mode and no fault is present, this key allows
entry into the Clear menu..
9
TOF
Moves paper downward from TOF (Top Of Form) alignment mark to the
print station and sets this as the first line of print on a page, independent of
forms length. If there are data in the buffers, the printer slews to the page
position where printing left off and prints the data.
9
VIEW
When the printer is online or offline, pressing this key executes the view or
eject function. A short press of the View key performs the view function. If
the key is held down for more than one second, the key eject function is
performed.
If online with data in the printer buffer, the data prints and the key functions
as described below.
For cabinet models, pressing the VIEW key moves the last data printed to
the tractor area for viewing. While in the view state, the message "Printer
in View" displays, and pressing the UP or DOWN arrow keys moves the
paper up or down in 1/72 inch increments. Pressing VIEW a second time
moves the paper back to the adjusted print position.
If in a fault state, this key will be ignored.
9
9
CONFIG
In offline mode, this key allows for fast selection of any of the previously
stored configurations. Pressing this key causes the printer to cycle through
the following messages: Load Config., Factory Config, Load Config 1,
Load Config 2, Load Config 3,...,Load Config 8.
9
Summary of Contents for 6600 Series
