Tally T2265 SprintPro, Maintenance Manual

Page: 102 / 178

5.8
Remove
Carriage System
– Remove the casing (section 5.1)
– Remove Upper Friction Drive (section 5.9)
– Release the Belt thightener on the left side “A”
– Unlock Carriage Motor. Place it on a safe position not to damage the cables.
– Remove Drive Wheel (section 5.15)
– Remove hindering toothed wheels
Attention:
When assembling observe the dashes of the wheels. They must fit in the
appropriate positions! (see 3.2.4)
– Remove the circlip on the right side of the carriage shaft “C”
– Pull the carriage shaft in left direction while prying the catch “D”
– Release the both springs “E” on both side walls
– Remove the lever “F” by pulling it carefully in the almost backward position to the
left
Caution:
Be aware that you may damage the lever if you pull outward in the wrong
position.
Before lifting the carriage system make sure not to damage the incremental
stripe. Push the stripe out of the light barrier on the bottom of the carriage!
– Push the carriage system a little to the left and lift it on the right side “G”.
Caution:
When reassembling you have to adjust
1:
the Gap Printhead / Platen and
2: the Parallelism between Head and Platen.
3. Adjust AGA.For further details please see chapter 6 “Adjustment”
/ Toothed Belt
Remove Carriage System Instructions for Disassembly and Assembly
5-20