Tally Dascom 7010, Maintenance Manual

Page: 117 / 255

3-6. Adjustments
3-43
(2-1) Init Fix-Thru sensitivity adjustment
Init Fix-Thru sensor is the transparent sensor (fixed type), i.e. SA, Sensor U (Fixed type).
Preparation:
1. Prepare recommended media or media to be used.
2. Peel off labels from the liner.
3. Open the head block and the sensor arm, and then set the media.
4. Be sure that the media is put on the SA, Sensor Bottom (Fixed type). If the media has
black mark, avoid that area.
5. Close the sensor arm and the head block.
Procedure:
1. Enter Factory/Service mode by turning on the power while pressing and holding the
[MENU]
,
[FEED]
and
[STOP]
keys.
“Factory Setup” main menu appears.
2. In “Factory Setup” main menu, press the
[STOP]
(
X
) key to enter Factory Setup mode.
The first submenu “Sens Vol Adj.” appears.
3. Press the
[MENU]
(
T
) key until “Init Fix-Thru” submenu appears.
4. Press
the
[STOP]
( X ) key to enter Init Fix-Thru sensitivity adjustment mode.
5. Press
the
[MENU]
( T ) key to select “Exec”.
6. Press
the
[STOP]
(
X
) key to execute adjustment.
Adjustment starts and the following screen is display. (Media is not fed.)
W X
Init Fix-Thru
No
Exit Enter
S
T
W X
Init Fix-Thru
Exec
Exit Enter
S
T
W X
Now !!
Executing
Exit Enter
S
T
W X
Factory Setup
Init Fix-Thru
Exit Enter
S
T