Tally Dascom 7010, Maintenance Manual

Page: 114 / 255

3-5. Disassembly, Reassembly and Lubrication
3-40
(7) Removing Rollers
Note:
The parts location Nos. (e.g. [2-61]) show the ones for 7010R. Refer to the Drawing No.
2 “Unit, Rewinder” for the Rewinder Part in Chapter 5 “Parts List”.
(7-1) Measure Sensor Rollers (4 pcs.)
1. Remove the Rewinder Mechanism block referring to “ (2) Removing the Rewinder
Mechanism block ”.
2. Disengage 2 E-rings (E-Ring, 3) [2-61] on both sides and pull out the Damper Shaft [2-6] to
remove 4 Measure Sensor Rollers [2-7].
(7-2) Damper Roller (3 pcs.) of the Rewinder Cover block
1. Open the Rewinder Cover.
2. Disengage 2 E-rings (E-Ring, 3) [2-61] on both sides and pull out the Damper Shaft [2-6] to
remove 3 Damper Rollers [2-22].
(7-3) Damper Roller (4 pcs.) of the Rewinder Mechanism block
1. Remove the Rewinder Door referring to “ (3) Removing the Rewinder Door and SA1,
Peeler ”.
2. Disengage 2 E-rings (E-Ring, 3) [2-61] on both sides and pull out the Guide Roller Shaft
[2-21] to remove 4 Damper Rollers [2-22].
(7-4) Peel Roll on the Printer part
1. Open the Rewinder Cover.
2. Remove 2 screws (PH (SW+PW), M3x5) [1-49] and detach the SA2, Peeler [1-45].
3. Disengage 1 E-ring (E-Ring, 4) [4-9], remove the Peel Roller Bushing2 [4-8], and pull out
the Peel Roll [4-1].
(8) Removing SA, Rewinder PCB
Note:
The parts location Nos. (e.g. [2-59]) show the ones for 7010R. Refer to the Drawing No.
2 “Unit, Rewinder” for the Rewinder Part in Chapter 5 “Parts List”.
1. Remove 4 connectors (J501, J502, J503 and J504) from the SA, Rewinder PCB [2-59].
2. Remove 4 screws (PH (PW+SW), M3x5) [2-64] and detach the SA, Rewinder PCB [2-59].