Tally Dascom 7010, Maintenance Manual

Page: 105 / 255

3-5. Disassembly, Reassembly and Lubrication
3-31
9. Remove the Tension Pulley [9-27].
1) Disengage the Tension Spring [9-30] from the Tension Plate block.
2) Disengage 1 E-ring (E-Ring, 3) [9-37] and pull out the Tension Plate block to the right.
3) Disengage 1 E-ring (E-Ring, 2) [9-38], pull out the Tensioner Pin [9-28], and remove the
Tension Pulley [9-27] from the Tension Plate [9-29].
Notes on reassembling:
• Correctly hook the Tension Spring [9-30]. (Refer to Drawing No. 9 “Unit, Frame” in Chapter 5
“Parts List”).
• Apply grease (Floil G-311S) to the Tensioner Pin [9-28] (refer to the places marked with  in
Drawing No. 9 “Unit, Frame” for the Printer Part in Chapter 5 “Parts List”).
10. Remove the SA, Connect PCB [9-20] (7010/7010-300).
1) Disconnect the SA, Option Cable 1 [9-21] (J15) and SA, Option Cable 2 [9-22] (J16) from
the SA, Connect PCB [9-20].
2) Remove 2 screws (PH (SW+PW), M3x6) [9-34] and detach the SA, Connect PCB [9-20].
11. Remove the SA, Frame Center [9-19].
1) Remove 4 screws (PH (SW+PW), M3x6) [9-34] and detach the SA, Frame Center [9-19]
from the SA, Frame [9-10].