By default, TalkSwitch is set to Serial connection. To activate USB connection, dial
91
from an extension then reset TalkSwitch. To return to Serial connection, dial
90
and reset TalkSwitch.
The ‘PF’ box in between E4 and L1/L2 represents power failure support. In the event
of a power failure or loss of power to the TalkSwitch, Extension 4 will be able to receive
calls and make calls on Line 1.
1.3.2
The TalkSwitch 48LS
Jacks/Ports
What to plug in
M U S I C
Plug in a radio, CD player, PC soundcard or any other
device that emits an audio signal if you wish to use
TalkSwitch's Music-on-Hold feature. This is a 1/8" (3.5
m m ) p h o n o j a c k .
Mono cables are recommended.
P A
Connect to a P.A. system if you wish to use the external
paging feature. This is a 1/8" (3.5 mm) phono jack.
Mono cables are recommended.
L A N P O R T
You can connect to an Ethernet hub using a Category 5
cable with RJ-45 connectors. For future use.
E 1 - E 8
Plug in any analog device that uses a standard (RJ-11)
t e l e p h o n e j a c k , s u c h a s : t e l e p h o n e s , a n s w e r i n g
m a c h i n e s , f a x m a c h i n e s , i n t e r n a l o r e x t e r n a l P C
m o d e m s , e t c . O n c e t h e s e d e v i c e s a r e p l u g g e d i n ,
TalkSwitch will recognize them as Extensions 111 to
1 1 8 .
L1/L2, L2, L3/L4, L4
This is where you plug in your telephone lines (RJ-11).
If you have 2 lines out of 1 phone jack, you can plug into
the 1/2 and 3/4 jacks.
4
TalkSwitch User Manual
TS-user manual_Final_3rd.qxd 8/9/01 2:14 PM Page 4
